Electrical equipment often breaks down, 1 of the most urgent tasks is the problem of short circuit of the CD drive. In these.
After the fall, the Xiaomi mi5s phone crashed the display. Let’s consider how to replace the Modular display on this series.
vsepochinim Cell Phones Apple iPhone 4S
It’s no secret that even very expensive and reliable mobile devices fail. This happens for various reasons, ranging from improper and careless operation. Ending with a long operating time. Today we will look at how to perform the process of replacing the connector, as well as the microphone in a device such as the iPhone 4S.
To begin with, we open the back cover, at the end there are two bolts that need to be unscrewed. It is worth paying attention to the fact that it is undesirable to repair this device with ordinary tools, they need special screwdrivers. So, we shift the top cover and before us is the “inside” of the iPhone 4S.
First, remove the battery by unscrewing two bolts. Then you need to remove the grounding under the network, by pulling it out from under the connector. We move it very carefully, it is desirable to produce this process with tweezers. If you move her hand, you need to do this very carefully, careless movements can lead to problems with the network. We unfasten the connector from the battery, and carefully, because you can remove it together with the connector for the board, and then you have to solder the motherboard.
Video: How to Replace an Iphone 4s Charging Connector
You take up the strap, thus pulling the battery from the case. If the battery is too stuck, and the strap has come off, then poke it with something thin around the perimeter and remove it from the case with your hands. The main thing is that it remains intact, since the slightest damage to the top layer can ultimately lead even to ignition of the battery, its bloating. Next, unscrew the next two bolts holding the connector for charging, remove the protection, then unfasten the cable with tweezers, and also disconnect the cable to the network.
We unscrew the bolts that hold the speaker. We remove it, and we see the charging connector. Here we first need to unfasten the button, lifting it up. We also unscrew the two bolts, pull out the microphone and pull the cable to the side and up so that the microphone comes off, which is what we needed, we have a charging connector and the microphone itself. The rubber band, which is located near the microphone, must be removed.
If necessary, we replace the old microphone with a new one, like the charging connector, which we carefully remove, clean the place for a new one and put it back in place. Everything is quite simple, the main thing is to know the sequence of disassembly steps so as not to forget anything. A very important factor in this matter is the accuracy of the user, which means that any process in disassembling the phone must be done carefully and carefully, otherwise you can accidentally disable other parts of the phone.
When assembling the phone, do not rush anywhere, do not forget about the small details, because if you forget to install any part in place, you will have to disassemble it again and then assemble the device again.