The design of this iPhone model is not very different from the previous model. If you decide to do an independent repair of iphone 5s, then be patient and you will succeed.
IPhone 5s is the first phone in the world with a 64-bit processor. Instead of the Home button, this model has a Touch ID sensor.
IMPORTANT! Carrying out an independent repair of the iPhone 5s, it should be borne in mind that during such repairs, you can damage the equipment and lose the official warranty on this device. Thus, disassembling the device you take full responsibility for damage that may occur during the work you are doing.
Repair prices for Apple iPhone 5s in rubles, including spare parts
Video tutorial for parsing iPhone 5s
IPhone 5S Self-Parsing Guide
If you want to repair your iPhone 5s yourself or just look at it from the inside, then you should know the algorithm for disassembling the device yourself.
First of all, before starting the analysis, be sure to turn off the device. After which you will need to unscrew the 2 screws that can be seen at the bottom of the phone near the connector.
Pick up a good, new suction cup. Using this tool, you can accurately, without negative consequences, separate the display from the base. Just work carefully so as not to damage the fragile, highly sensitive sensor optics.
Then it is necessary to disconnect the loop from the Home button, in which the Touch ID fingerprint sensor is mounted.
So, we disconnected the “Touch ID”, but do not stop raising our display further.
Remove the device battery with gentle hand movements. In this iPhone model, the battery is securely attached to the device. There is no special tail, thanks to which you can quickly remove the barate.
Video: Disassemble Iphone 5s Video
Apple has stated that the battery of this phone model is capable of much. In particular, experts say that she can hold more than ten hours in dialogue mode. Well, well, there is an opportunity to check whether such statements are justified.
Disconnect the retina display module with sensor. Note that replacing the fingerprint sensor of this model is easier than repairing the home button in the iPhone 5 model.
Carefully pry the sensor with a spatula and take it out.
We take out the camera with careful, leisurely movements. Remember that you should not use excessive force when disassembling the device, be extremely careful.
Now it’s time to work with the motherboard. We take it out very carefully, wielding a plastic tool.
If you want free access to the Face Time camera, you will need to remove a few small screws.
At the bottom of the phone you can see an eight-pin connector, a headset output, and a microphone. We untwist all the screws located in this part, we take out the board.
Well, our iPhone 5s is taken apart.
In the event that you want to assemble the device back, then these instructions should be used in the reverse order. Do not forget to use special tools (suction cup, different types of screwdrivers, spatula). Such equipment will allow you to do the job efficiently and quickly!